C ollection
15
Check that the two red buttons have snapped out, otherwise the door cannot be closed..
CORRECT
INCORRECT
The two red buttons have
snapped out CORRECTLY
The two red buttons have not
snapped out
•replace the drip tray, complete with the grounds container;
• close the service door.
NOTE 1: If the infuser is not inserted correctly until it clicks into place and the two red buttons have not snap-
ped out, the service door cannot be closed.
NOTE 2: if it is hard to insert the infuser, before inserting it,squeeze to size by pressing
it vigorously from above and below at the same time, as shown in Figure.
NOTE 3: If it is still hard to insert the infuser, leave it out of the appliance, close the service door, unplug from
the mains, then plug in again. Wait for all the lights to go off after the self-diagnosis, then open the door and
replace the infuser.
16.3 Cleaning the milk container
Proceed as follows:
•Remove the milk spout and intake tube (see figure).
•Wash all the components thoroughly with hot water
and washing-up liquid.
•Make sure there are no milk residues inside the two
holes in the lid of the milk container indicated by the
arrows in the figure.
•Replace the intake tube and milk spout, after making
sure they are not clogged with milk residues.
17 CHANGING AND SETTING THE MENU PARAMETERS
After pressing the button when the appliance is ready, you can use the internal menu to modify the follo-
wing parameters and functions:
•Clock
•Auto-start time
•Auto-start
•Descaling process
•Coffee temperature
•
Length of time the appliance remains on (turn off after)
•Water hardness
•Factory default values
•Washing process
•Beep ON/OFF
Note: the last line of the display is the guide to the function buttons
Comments to this Manuals