DeLonghi ESAM 5400 User Manual download pdf (Page 9)

9

“ESC” button to exit from the selected

function and go back to the main menu).

B9. P button: to access the Programming

menu.

B10. button: turns the appliance on and off

(stand by).

Explanation of lights

The Hot Water function is selected.

The Steam function is selected.

The rinse cycle is selected.

Indicates the need to descale the applian-

ce.

Light: no water or water tank absent

Light ﬂashing: the machine is heating up

or a rinse cycle is underway.

The appliance is delivering two cups of

coffee.

An alarm is displayed on the control panel

(see the section: “Explanation of lights”).

Light on steadily: the grounds container is

missing and must be inserted in the ap-

pliance; Light ﬂashing: the grounds con-

tainer is full and must be emptied.

Indicates the button to press to exit the

programming menu or selected function.

Indicates the button to press to conﬁrm

the function selected in the programming

menu.

“Energy Saving” mode is active.

PRELIMINARY CHECKS

Checking the appliance

After removing the packaging, make sure the

product is complete and undamaged and that all

accessories are present. Do not use the applian-

ce if it is visibly damaged. Contact De’Longhi

Customer Services.

Installing the appliance

Important!

When installing the appliance, respect the fol-

lowing safety warnings:

• The appliance gives off heat. After positio-

ning the appliance on the worktop, leave a

space of at least 3 cm between the surfaces

of the appliance and the side and rear walls

and at least 15 cm above the coffee maker.

• Water penetrating the coffee maker could

cause damage. Do not place the appliance

near taps or sinks.

• Theappliancecouldbedamagedifthewater

it contains freezes.

Do not install the appliance in a room where

the temperature could drop below freezing

point.

• Arrangethepowercableinsuchawaythatit

cannot be damaged by sharp edges or con-

tact with hot surfaces (e.g. electric hot pla-

tes).

Connecting the appliance

Important!

Check that the mains power supply voltage cor-

responds to the value indicated on the rating

plate on the bottom of the appliance.

Connect the appliance to an efﬁciently earthed

and correctly installed socket with a minimum

current rating of 10A only.

If the power socket does not match the plug on

the appliance, have the socket replaced with a

suitable type by a qualiﬁed professional.

Using the coffee maker for the ﬁrst time

Please note :

• Coffee has been used to factory test the

appliance and it is therefore completely

normal for there to be traces of coffee in the

mill.

The machine is, however, guaranteed to be

new.

• You should customise water hardness as

soon as possible following the instructions

in the section “Setting water hardness” on

page 17.

1. Remove the water tank, ﬁll to the MAX line

with fresh water then replace in the appliance

(ﬁg. 1).

2. Turn the cappuccino maker outwards and

place a container with a minimum capacity

of 100 ml underneath (ﬁg. 2).

3. Plug the appliance into the mains socket and

place the main switch on the back of the ap-

pliance in the I position (ﬁg. 3).

4. The light comes on and OK ﬂashes.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 23 24

Comments to this Manuals

Piersilvio 29 Sep 2024 | 19:42:31

grazie