DeLonghi PAC 360 Specifications download pdf (Page 8)

TEMPORARY INSTALLATION

Note: In both cases (permanent and temporary installations) make sure that the Pinguino is posi-

tioned on level ground. If necessary use the two caster stops for the front casters

This installation makes it easy

to use Pinguino in any room,

provided there is a window or

a door: it allows you to use the

Pinguino immediately.

Suction discs may be used to

keep window or door closed.

Pinguino is equipped with an

adjustable window bracket. If

you have a sash window,

place the bracket on the win-

dow sill, extend the bracket

fully within the window frame

and lower the window onto the

bracket. Insert the nozzle of

the exhaust hose into the slot,

then connect the hose to the

air conditioner (fig.7). Thanks

to the wing nut, it’s possible to

use the window bracket also for

sliding windows. Position the

hole of the bracket so to allow a

correct installation of the exhau-

st hose (see the following

instructions).

30 cm

SET UP INSTRUCTION

For permanent installation place the Pinguino near the outlet opening in wall or window (where it is

meant to be used). The diagram below shows the correct way to installl the exhaust hose.

1) Water collects at this point 2) Bend this section 3) Bend this section

NO YES YES

fig. 5 fig. 6

fig. 7

fig. 8

window

bracket

GB 18-01-2001 16:26 Pagina 8

1 2 3 4 5 6 7 8 9 ... 17

No comments

DeLonghi PAC 360 Specifications Page 8