RINSING
15.When the water tank is empty, the appliance displays the message:
RINSING COMPLETE PRESS OK
16.Press the OK button and refill the water tank with clean water.
17.The descale programme is now terminated and the appliance is ready to make coffee again.
NOTE: if the descaling cycle is interrupted before completion, the appliance continues to display the descale
message and the programme must be started again from the beginning. Empty the water tank, rinse, fill with
clean water and run off a cup of hot water.
IMPORTANT: FAILURE TO DESCALE THE APPLIANCE REGULARLY INVALIDATES THE GUARANTEE.
16.4 CHANGING COFFEE TEMPERATURE
The appliance is factory preset to medium coffee temperature. To change the temperature of the coffee, pro-
ceed as follows:
1. Press the button (the light over the button comes on) then press the button repeatedly until
the appliance displays:
HIGH TEMPERATURE.
2. Press the button until the appliance displays the required coffee temperature.
3. Press the button to confirm the temperature selected;
4. Press the button to exit programming mode or to change other parameters.
16.5 Changing the length of time the appliance remains on
The appliance is factory preset to go off automatically one hour after the last coffee has been made.
The number of hours the appliance remains on (max. 3) can be increased as follows:
1. Press the button (the light over the button comes on) then press the button repeatedly until the
appliance displays: OFF AFTER 1 HOUR.
2. Press the button to change the number of hours the appliance remains on.
3. Press the button to confirm the value;
4. Press the button to exit programming mode or to change other parameters.
16.6 Setting water hardness
The descale message is displayed after the appliance has been operated for a factory set period of time cal-
culated on the basis of the maximum quantity of lime scale which may be contained in the water used.
If necessary, this period of operation can be extended, making descaling less frequent, by programming the
appliance based on the actual lime content in the water used.
Proceed as follows:
1. remove the "Total Hardness Test" strip (enclosed on page 2) from its packaging then dip it fully in the
water for a few seconds. Remove it and wait around 30 seconds (until it changes colour and a number
of red dots are formed);
2. Turn the appliance on by pressing the button (fig. 6).
3. Press the button then press the button repeatedly until the appliance displays:
WATER HARDNESS 4
4. Press the button repeatedly until the number coincides with the number of red squares on the
test strip (for example, if there are 3 red squares on the test strip, press the button until WATER HARD-
NESS 3 is displayed).
5. Press the button to confirm the value; The coffee maker is now programmed to provide the desca-
ling warning when necessary, based on the actual hardness of the water.
35
GB
Comments to this Manuals