DeLonghi ECAM26.455 User Manual Page 14

  • Download
  • Add to my manuals
  • Print
  • Page
    / 22
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 13
13
coee buttons ( or ).
t "UUIFFOEPG EFMJWFSZ UPJODSFBTFUIF RVBOUJUZ PG DPòFF
in the cup, just press (within 3 seconds) one of the coee
buttons (
or ).
Once the coee has been made, the appliance is ready to use
again.
Please note!
t 7BSJPVTBMBSNNFTTBHFTDPVMECFEJTQMBZFEXIJMFVTJOH
the machine (ll tank, empty grounds container, etc.).
Their meaning is explained in the section “Displayed
messages” (page 20).
t 'PSIPUUFSDPòFFTFFUIFTFDUJPOi5JQTGPSBIPUUFSDPòFFw
(page 12).
t *GUIFDPòFFJTEFMJWFSFEBESPQBUBUJNFUPPXFBLBOE
not creamy enough or too cold, read the tips in the
“Troubleshooting section on page 21.
Making coee using pre-ground coee
Important!
t /FWFSBEEQSFHSPVOEDPòFFXIFOUIFNBDIJOFJTPòPSJU
could spread through the inside of the machine and dirty
it.
This could damage the appliance.
t /FWFSVTFNPSFUIBOMFWFMNFBTVSFPSJUDPVMEEJSUZUIF
inside of the coee maker or block the funnel.
Please note!
If you use pre-ground coee, you can only make one cup
of coee at a time.
1. Press the
button (g. 9) until “Pre-ground” is
displayed.
2. Open the beans container lid; then open the pre-ground
coee funnel lid by pushing on PUSH and, once released,
open the lid.
3. Make sure the funnel is not blocked, then add one level
measure of pre-ground coee (g. 17).
4. Place a cup under the coee spouts.
5. Press the 1 cup coee button
(g. 11).
6. Preparation begins. The amount of coee selected is
displayed together with a progress bar which gradually
lls as preparation progresses.
Please note!
If “Energy saving” mode is enabled, you may have to wait a few
seconds before the rst coee is delivered.
MAKING DRINKS WITH MILK
Please note!
t 5PBWPJEQSPEVDJOHNJMLXJUIQPPSGSPUIPSMBSHFCVCCMFT
always clean the milk container lid and hot water nozzle
as described in the section “Cleaning the milk container”
on pages 14 and 17.
Filling and attaching the milk container
1. Remove the lid (g. 18);
 'JMMUIFNJMLDPOUBJOFSXJUIBTVóDJFOURVBOUJUZPGNJML
not exceeding the MAX level marked on the container (g.
19). Each mark on the side of the container corresponds
to 100 ml of milk.
Please note!
t 'PSBEFOTFSNPSFFWFOGSPUIZPVTIPVMEVTFTLJNNFE
or partially skimmed milk at refrigerator temperature
(about 5°C).
t *Gi&OFSHZ4BWJOHwNPEFJTFOBCMFEZPVNBZIBWFUPXBJU
a few seconds before the rst drink is delivered.
3. Make sure the milk intake tube is correctly inserted in the
bottom of the milk container lid (g. 20).
4. Place the lid back on the milk container.
5. Remove the hot water spout from the nozzle.
6. Attach the container to the nozzle and push as far as it
will go (g. 21). The machine emits a beep (if the beep
function is enabled).
 1MBDFBTVóDJFOUMZMBSHFDVQVOEFSUIFDPòFFBOEGSPUIFE
milk spouts. Adjust the length of the milk spout. To move
it nearer the cup, simply pull it downwards (g. 22).
8. Follow the instructions below for each function.
Adjusting the amount of froth
Turn the froth adjustment dial on the milk container lid to
adjust the amount of froth on the milk delivered while making
drinks with milk.
Dial
position
Description Recommended for
No froth
FLAT WHITE
/
HOT MILK
Min. froth
LATTE
Max. froth CAPPUCCINO
Page view 13
1 2 ... 9 10 11 12 13 14 15 16 17 18 19 20 21 22

Comments to this Manuals

No comments